Curious about Actual Huawei HCIP (H35-481_V2.0) Exam Questions?

Correct : A

According to Huawei official documentation, using the MAE-Deployment (radio network planning data file) method is recommended for modifying the cell bandwidths across the entire network during gNodeB data reconfiguration. This method allows for the efficient and accurate modification of cell bandwidths by using a radio network planning data file to update the configuration of multiple gNodeBs at once.

Correct : B

The network layer in the transport protocol stack provides functions such as addressing and route selection. It is responsible for finding the best route for data packets to travel from the source to the destination. It also provides logical addressing and packet routing. The network layer does not provide the transmission of binary data flows, MAC forwarding, or physical medium access.

https://www.oecd.org/education/skills-beyond-school/AHELOFSReportVolume1.pdf

ASSESSMENT OF HIGHER EDUCATION LEARNING OUTCOMES

https://www.oecd.org/education/skills-beyond-school/AHELOFSReportVolume1.pdf

https://about.usps.com/publications/pub32/pub32_terms.htm

Postal Terms

https://about.usps.com/publications/pub32/pub32_terms.htm

https://www.ohsaa.org/sports/bk/2014-15BasketballQ&A.pdf

Basketball Frequently Asked Questions

https://www.ohsaa.org/sports/bk/2014-15BasketballQ&A.pdf

Correct : A, D

In NSA networking, In self-setup scenarios, the USERPLANEHOST and SCTPHOST objects are unnecessary to configure for a gNodeB. The USERPLANEHOST object is used to configure the IP address of the user plane host, and the SCTPHOST object is used to configure the IP address of the SCTP host. In self-setup scenarios, the gNodeB automatically obtains the IP addresses of the user plane host and SCTP host from the S1-MME or S1-U peer. The USERPLANEPEER and SCTPPEER objects are necessary to configure for a gNodeB in SI self-setup scenarios. They are used to configure the IP address of the user plane peer and SCTP peer, respectively.

Correct : A

The PING, TRACERT, CFMTRACE, CFMPING, and UDPECHO commands cannot be executed simultaneously on the same board in a gNodeB. Executing multiple commands at the same time can cause system instability, so it is not recommended to do so.

Correct : A

According to the Huawei official documentation, a gNodeB supports up to 4 OM channels at most. These channels can be used to monitor and manage the gNodeB remotely. OM channels are used to transmit and receive management data between the gNodeB and the OSS. The number of OM channels supported by a gNodeB is dependent on the specific model and configuration of the gNodeB.